Experience the enhanced performance of honed out motorsports in Terre Haute IN
Extrude Hone was instrumental in pioneering an abrasive flow machining process for increasing fuel and air flow in automotive engines. Today our process is the gold standard for honed out motorsports in Terre Haute IN. Our process is ideal for all kinds of car, truck, and motorcycle engines including:
- 2-stroke, 4, 6, 8, 10, or 12 cylinders
- Hemis
- Diesels
- Turbos
- Aluminum
- Cast iron
How Our Process Works
Honed out motorsports in Terre Haute IN is based on the principle that optimizing the passages your air and fuel flows through will enhance performance. At Extrude Hone, we accomplish this using a state of the art abrasive flow machining process that enables us to evenly remove up to 1 mm of material from all interior surfaces of a given part.
After over 30 years of experience in automotive abrasive flow machining, we’ve mastered the art and science of this process. We’ll make sure your job is properly set up with the right size abrasive grit, the right consistency of polymer media, and the right flow pressure to remove the precise amount of material that is needed to enhance performance on a given part. Because the polymer media recirculates the silicon carbide abrasive particles, there is always fresh abrasive at the surface to deliver a highly precise, uniform finish.
Benefits of a Honed Out Intake Manifold
Honing any part of an internal combustion engine will help increase fuel and air flow. However, the key part to address for honed out motorsports in Terre Haute IN is the intake manifold. After the intake manifold has been honed, flow capacity will increase about 25 percent. With better volumetric efficiency in the intake manifold, fuel will burn better, the cylinder will be more completely evacuated, and you’ll get a stronger measure of fuel and air for the next ignition. This results in:
- Increased horsepower
- More thrust
- More torque
- Better fuel efficiency
- Reduced emissions
What About the Exhaust Manifold?
Exhaust manifolds can certainly be honed. This is often necessary for situations where adding a header is not allowed due to race rules, not practical due to lack of available aftermarket parts, or not desirable due to concerns about authenticity.
Get the Best Services for Honed Out Motorsports in Terre Haute IN
Extrude Hone is your go-to provider for services for honed out motorsports in Terre Haute IN. We have the best state of the art equipment along with an extensive in-stock inventory of abrasive media. We can hone aluminum parts in 7 to 11 working days and cast iron parts in 3 to 4 weeks.Call us at (562) 531-2976 now to get started.
